I am sure you probably could get FL Studio to run as well with some time and research.

My main troubles with Wine were when I tried to get Roblox to run under it. It ran, but only barely, and I don’t quite know why, but I had to use Grapejuice to get it to run without feeling like it was running on a low-end computer from 2005.

You have to escape the dash, otherwise it becomes a bullet point.

You have to escape dashes, otherwise you get a bullet point.

-

versus

Source:

You have to escape dashes, otherwise you get a bullet point.

 \-

versus

 -

I was thinking someone could make a firmware like Tasmota but for printers that can be installed on many existing printers, and a company could make a printer that runs that is designed to run that firmware just like how you can get smart home devices designed to run Tasmota. Also, we just need printers that properly support IPP.

The only issue I have with Ardour is that all plugins need to be installed separately (assuming OP hasn’t installed them already).

I recently purchased a copy of Ardour, and I have noticed that, but I have found most basic plugins can be found for free.

nothing wrong with more options :)

Options are key.

Ardour should be able to do that.

I don’t believe LMMS can do audio tracks, so Ardour would be the one to go with.

It could also be similar to the timelines, where there is a menu to either show everything or filter to one of the other options there currently.

!canvas@toast.ooo (this link will open the community on the user’s own instance)

I am planning on writing a graphical interface for gphoto2 (a Linux camera remote library) which will allow for tethered shooting and some other neat things (like using a computer as an intervalometer). I might also write a web interface for it, so it will allow for using a table or phone to remote control a camera and allow the user to check on timelapses, but it will take a while to get it all to work.

I have been experimenting with using Inkscape and OpenSCAD for 3d modeling, and it seems to work for what I do, but I know quite a few people prefer a more graphical interface than OpenSCAD.

Wine can be difficult to get working right (I have tried to use Wine for a few things before and I also had issues with it that I couldn’t solve), so it doesn’t surprise me that it doesn’t work right for you. It is a miracle that they can get any apps to run on a completely different operating system, and audio software tends to be very complicated and often depends on system APIs.

You can put spoilers in

Source:

You can put spoilers in
::: spoiler spoiler tags.
Hello!
:::

Or just go to https://lemmyverse.net/

I wonder if even just an open source firmware for printers could work.

I have a Brother printer that barely works with anything, but on Linux it works perfectly fine.

It looks like at least FL Studio can work with Wine, but you have to use ASIO for audio.

This is a great list of communities! Nice to see that !illegallysmolbirbs@mander.xyz made it on here.

I think music production software uses some system APIs that might not even be possible to replicate with Wine or Proton.