chgowiz

I tried a Creality Ender 3 a couple of years ago. Struggled a lot, for me, it required a lot of aftermarket replacements to make it work well. I sold it about 6 mo later.

In Mar, I bought an Anycubic Kobra. Out of the box, worked like a champ and has continued to. None of the struggles I had with the Ender. Only add on was a sensor to let me know when I’m out of filament.

You’ll probably hear from folks who bought an Ender and had great success, and folks who struggled w/a Kobra, though. It’s like an automobile… you’re going to hear good and bad stories for each model.

Honestly, I read a lot of articles and just found what fit my use case, expectations and budget. Your first one will definitely be a learning experience.

Good luck!

I played “Advanced Dungeons & Dragons” on the Intellivision that my g/f had at the time. Most everyone else had Atari 2600s, so it felt rare (at the time) to play on it. It had a funky controller with weird keypads and a disc that was like a joystick, but hard to play with.

https://en.wikipedia.org/wiki/Advanced_Dungeons_%26_Dragons:_Cloudy_Mountain

Aren’t the batteries and electric motors driving the grid fins at the top of the booster? That and the entire interstage are gonna get blasted with the thrust plume of three Raptors. Reinforcing them enough that it doesn’t affect planned reusability targets could take a bigger bite out of the payload than they get from hot staging.

That was my first thought, or that the header tank up at the top might not like being heated like that.

I’m sure they’ll figure out pretty quickly if it works or not.

Going to be interested in how they make that work with the intended recoverability of the booster. Excitement guaranteed, for sure!

I think Soyuz boosters currently do hot staging, the interstage is open IIRC.