the cool thing is these are turret-grade autocannons, not the shoulder-fired version, so they have enough armor pen and damage to handle even heavies given enough hits.

Helldivers is Sony IP, not Arrowhead IP, so no, Arrowhead can’t just release another game in the series without Sony’s involvement.

Sweet liberty, my ass!

Just… get better at placement…?

not me running eruptor/stalwart like the stalwart was my primary and the eruptor was my support weapon.

I actually gave up on the order halfway through, ngl. I hate the stalwart so much on higher levels.

I dunno on that one, I think it’s likely we’d been slowly liberating/defending a handful of planets for the first half of the order’s time allotment, and finally pushed them over the line in the latter half.

Big recommend to just jump straight to OrcaSlicer. It has Bambu Studio’s much-improved-over-PrusaSlicer UI but with features ported in from PrusaSlicer and SuperSlicer and compatibility with non-Bambu printers.

This is fantastic. Is the file hosted anywhere?

Plus it’s an affordable giant plushie, so it’s great for people who want something big and soft to cuddle, like say trans people on new hormones going through big emotions.

This is definitely not true of OrcaSlicer, at least not anymore. I’m running an 0.6mm nozzle and 120% layer width at 0.2mm layer height results in 0.72mm line width, not 0.24mm.

Another OrcaSlicer user here. Started off with PrusaSlicer and switched over at a friend’s recommendation, and honestly am so glad I did (it has a much nicer UI and some really neat features ported over from SuperSlicer).

These look great! Can we get a link to the design, please?

EDIT: nvm, found it!

Thanks, and good luck! In Orca, I set it to all walls fuzzy, 0.5mm between points, and 0.2mm depth, and I like the results.

Thanks for showing us this! I printed one with “fuzzy skin” and it is so cool (unfortunately doesn’t show up well in photos though).

SV06 Plus, SV07, and SV07 Plus all use the same nozzles. However, I think standard volcano nozzles would also work – I just haven’t bothered to try since I bought a five-pack of the proprietary nozzles off AliExpress and they work perfectly fine.

Yes, adaptive cubic varies the density of the cubic structure to decrease filament usage while supposedly maintaining the same strength as normal cubic. And, in my own experience, gyroid always takes longer to print than adaptive cubic – sometimes it only adds a few minutes, but I’ve seen it add nearly half of the print time again for infill-heavy prints.

I just wish it didn’t take so much longer to print than adaptive cubic at the same infill percent.

The hint in this case is “God bless you”

That’s actually the abuse showing through. It’s intentional passive aggression and a manipulative speech pattern. It’s meant to imply, “God bless you, even though you’re breaking his rules and making him sad and probably going to hell”.

And before you ask, I was raised evangelical, was deeply involved in ministry, went to bible school, and even worked at a church for a few years; I know how these people think because I was one until I saw the light and ditched their religion. The number of times I’ve seen “I’ll pray for you/them”, “God bless you/them”, and such used as insults is too damn high.