poofy_cat@lemmy.worldto3DPrinting@lemmy.world•My Cartridge Display Stand for the Switch DockEnglish
2·
1 year agogenius
genius
0.2 mm normal in prusaslicer. I scaled the model up 150%, which made some of the overhangs just a little too steep so there are a few small gaps near the top.
Transparent PETG, and it’s about 10" tall.
A whole lot lol. Replaced and heavily modified the extruder, extruder motor, filament runout sensor, bowden tube, hot end cooling fan, and part cooling fan/blower. Also had to take apart the hot end / heat break and clean out leaked globs that had stuck everywhere. Also modified the electronics cooling/intake fan setup with a dc/dc converter and 12v fans to reduce noise.
Cool, I didn’t know about this.